Wbox hd2 kaukosäätimen ohjelmointi

Sattuuko kukaan tietämään/muistamaan, että miten vanhan wbox hd2 kaukosäätimen "TV-nappi" ohjelmoitiin? Jotain näppäimiä piti painaa samaan aikaan??

Kommentit

  • Tämmöinen ohje löytyi englanniksi:

    Remote Control Unit – Additional Functions
    1. Learning Method
    TV button has a learning functionality that can be used to teach it commands from the remote control
    of your TV. Typically the learning function is used to learn the power command of the TV, but it can also
    optionally hold one other command. If the TV button is taught two commands, then pressing the button
    ; second press will send the second
    command.
    [Note] In LEARN MODE, if there is no further action within 30 seconds at any point, the remote control turns
    to normal operation mode switching the LED off.
    [Note] TV Power button doesn’t have default functionality unless the learning method is used.
    The Learning Method
    (1) Press TV and OK buttons at the same time for 1.5 seconds. This will turn on the LEARN MODE.
    • The Power LED ON will turn “ON”.
    (2) Press TV button.
    • The Power LED blinks once and will then be “ON”.
    (3) Press 1st SOURCE button (Power button of the original TV remote).
    • If it learns correctly, The Power LED blinks twice and will stay “ON”. To teach a second command,
    go to step (4). To return back to normal operation, go to step (6).
    • If it does not learn correctly, The Power LED blinks 5 times and will stay “ON”. To retry, go back to
    step (2). To return back to normal operation, go to step (6).
    • If there is no input signal for 30 seconds, the Power will LED blink 5 times and the remote will stay
    in learning mode. If no there is no further input signal for another 30 seconds, the remote will return to
    normal operation mode and the Power LED will be “OFF”.
    (4) Press TV Power button one more time.
    • The Power LED blinks once and will stay “ON”.
    (5) Press second SOURCE button (For example, any numeric button from the original remote control)
    • If it learns correctly, The Power LED blinks twice and will stay “ON”. To return back to normal
    operation, go to step (6).
    • If it does not learn correctly, The Power LED blinks 5 times and will stay “ON”. To retry, go back to
    step (4). To return back to normal operation, go to step (6).
    • If there is no input signal for 30 seconds, the remote will stay in learning mode after blinking 5 times.
    If no there is no further input signal for another 30 seconds, the remote will return to normal operation
    mode and the Power LED will be “OFF”.
    (6) To return back to normal operation mode, Press TV and OK buttons at the same time.
    • The Power LED blinks 3 times and will be “OFF”.
    2. Low Battery Warning Function
    This function can be used to check if the remote control batteries have a low voltage and need to be
    replaced soon.
    (1) When you press Power button, the power LED will blink 3 times if the voltage level is low (2.2V ~
    2.3V).
    (2) Learning mode cannot be used when the battery voltage level is low.
    Veikko

Kommentoi tai kirjoita uusi viesti

Nimesi ja viestisi näytetään julkisesti.Sähköpostiosoitettasi ei koskaan näytetä julkisesti.